1/16/2024 0 Comments Sea wolf rc submarineCheck out this and other projects of mine at www.rc-sub. Polycarbonate transparent tube 50mm x 300mm (diameter x length) €14. This is the third chapter in the buildup of my 96th scale Seawolf nuclear attack submarine buildup.Trumpeter Kilo – Fitting/conversion KIT €39.90 Add to cart.WTC Kit for the German Type XXIII 1:35 by Bronco Read more.Short servo compartment module for 50mm tube €25.90 Add to cart.The building thread of my personal Trumpeter Seawolf with lots of photos can be found HERE. This item requires extra time to ship as it needs to be assembled and TESTED. This is a fully assembled WTC, for an UNASSEMBLED KIT CLICK HERE. Trumpeter “USS SSN-21 Seawolf Attack Submarine” (05904) 1:144 model not included! Still required to make the WTC operational: standard seawolf fine diving procedure is: 1 run at maximus speed with rear dive plane little up to lower sub ass and add water on the prop (+10/15 of speed) 2 put down rear dive plane to dive nose under water (props go off water and turn on air) 3 when props go on air and nose is fully underwater (procedure is not reversible), put little down. The ribs for the lower hull with the WTC already slid in: Stern dive planes with a hinge like the real vessel! Stern mechanics: The ribs for the upper hull: Both of these subs are quite a lot of fun, but I want one that looks like a WWII sub, but maneuver like the. I tried to attach a picture I hope it shows up. I also have a Lindberg Gato that I converted to R/C. Slightly bigger dive planes and rudders allow better model manoeuvrability! I have a Nikko Sea Wolf sub that I've repainted to look like a real skipjack. Pushrod for the bow dive planes (with magnetic coupler).External rib for the Kilo bow planes pushrod (with magnetic coupler).2x Magnetic shaft connectors (Pair joining the propeller shaft with motor shaft).7x ribs (4 for the lower hull and 3 for the upper hull) as the WTC mount, they also allow for perfect alignment of the upper and lower hull.New set of rudders and dive planes for a full RC conversion.Fitting Kit (conversion KIT) for Trumpeter “USS SSN-21 Seawolf Attack Submarine” (05904), consists of : The fitting kit also allows for a perfect alignment of the upper and lower hull. TTROBOTIX RC Model Submarine Seawolf Ocean Master 5224-F15A11. It’s especially designed for the Trumpeter Seawolf and most likely will not fit other models. The fitting kit allows for an easy connection of the WTC with the plastic model. Ballast tank with “quick lock” connector for easy replacement.All plastic parts for the water tight container.2 x high quality Corona servos (metal bearings, metal gears).2S Li-Ion battery pack (Samsung or LG cells, 7.4VAh).Fitting KIT (conversion KIT) for “USS SSN-21 Seawolf Attack Submarine” (05904) 1:144.WTC Specs: Outer tube diameter: 50mm/1.96″ WTC External length (including cap ends and servo pushrods with magnetic couplers): 470 mm/18,50 inches WTC Length (from one end cap to another): 410 mm/16,14 inches Polycarbonate tube length: 400 mm/15.75 inches Just connect your RC receiver and place the WTC in your submarine model! Version including the Fitting/Conversion KIT. Description Fully Assembled WTC (RTR) for the Trumpeter “USS SSN-21 Seawolf Attack Submarine” (05904) or any similar size model.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |